Step 1:Open the printer and wait for the holder
Turn the printer on. Use the recessed grip on the side to lift the whole scanner unit until it holds itself open. Wait for the cartridge holder to come into reach and stop moving.
Watch this section at 0:15Step 2:Release the cartridge you’re replacing
Squeeze the tab on the locking cover and lift it. Grip the exposed corner of the cartridge, tilt it up towards you and lift it out. If you are installing the first cartridges, open the two empty locking covers.
Watch this section at 0:43Step 3:Seat the new cartridges before locking them
Remove the protective tape from a fresh cartridge. Leave the top label in place. With that label facing up, slide the colour cartridge into the left holder at a slight angle, then let it settle flat. Fit the black cartridge on the right the same way. The cartridge rests in the holder. Press the locking cover down until it closes securely.
Watch this section at 1:45Step 4:Lower the scanner unit
Lift the scanner unit slightly to release its support, then guide it down gently. The printer may make noise while it prepares the cartridges.
Watch this section at 3:28Read the estimated ink levels
With the printer registered and online in Canon PRINT, tap the printer itself. If this is your first visit, follow the service prompt. The printer status shows separate estimated ink levels for black and colour.
Watch this section at 4:00

