Power, copy and Stop buttons
- Power turns the printer on or off. A flashing power light indicates activity.
- The black-and-white copy button starts a monochrome copy; the colour-marked copy button starts a colour copy. Press again for additional copies.
- Stop is the triangle-in-a-circle button. Press it once to cancel the current print job.
Tell the two Wi-Fi indicators apart
The upper indicator represents the router Wi-Fi connection: steady green means connected. The lower indicator is for Wi-Fi Direct. Holding Wi-Fi starts pairing, with flashing indicators while it searches. If both lights flash together after setup times out, press Wi-Fi once, then hold it again to restart pairing.
Use Information for network reports
A short press of Information prints a network report. Holding it for about seven to ten seconds prints the longer report used for additional network details and the password lookup. Load paper before requesting either report.
Common button combinations
- With the printer on and the network lights idle, hold Wi-Fi and Information together to enable Wi-Fi Direct.
- With the printer off, hold Power and Information until the network indicators flash to reset its connections. You will need to reconnect afterwards.
- With the printer off, hold Power and Stop to request a nozzle-check pattern.
- With the printer on, hold Stop for about five seconds to start printhead cleaning.
Ink and paper indicators need a closer check
The orange ink and paper symbols point to ink or paper-related attention. The exact light combination matters. Use the orange-light troubleshooting guide for the relevant pattern instead of assuming every orange light means the same fault.


