A little preparation

Before you start

  • A4 or Letter paper loaded in the rear feeder.

With paper loaded and the printer on, press Information for around one or two seconds. The printed report lets you inspect the connection information the printer currently has, including Wi-Fi status and an IP address when a network connection is set up.

Step 1:Load A4 or Letter paper in the rear feeder

Put A4 or Letter paper into the rear feeder and position the paper support/guide against it as shown. Have the paper in place before requesting the report.

Step 2:Turn on the printer and press Information

Turn the printer on and check that the green power ring is lit. Press the Information button for around one or two seconds, then release it.

Step 3:Wait for the information sheet to print

The video shows the network lights flashing while the report is being prepared, followed by the printed sheet. Wait for that output rather than repeatedly pressing the button.

Step 4:Read the connection state on your sheet

Check the entries for the current Wi-Fi connection, IP address and Wi-Fi Direct information. In this demonstration the printer is not connected to Wi-Fi and has no network IP address reported; Wi-Fi Direct is not set up either. The report therefore describes an unconfigured connection rather than a successful network setup.

Use the report to choose the next step

If you need the printer’s current IP address, the related IP-address guide also shows where to find it on Windows. If the printer is not connected, use the setup or reconnect guide to establish the connection. Printing this report itself does not connect the printer to Wi-Fi.

A little extra help

Questions & troubleshooting

There is no IP address on my sheet. Did the report fail?

Not necessarily. The source successfully prints a report while the printer is not connected to Wi-Fi, and it consequently has no network IP address to show. Check the connection status before treating the missing address as a printing problem.

Does pressing Information set up Wi-Fi?

No. This procedure prints the current information. Use the separate setup guide to connect the printer.

Do I need a computer to print the sheet?

No. The demonstrated method uses the printer’s own Information button and paper.

References