Before you start
- A clean blank original and about five sheets for the rear feeder.
Use this for stray ink marks
This method is for unwanted ink marks on paper that should be blank. It uses blank copies to pass paper through the printer. Missing lines within a printed image are a different problem; check the print-head cleaning and alignment guides for those.
Step 1:Place a blank sheet on the scanner
Lift the scanner lid and place a clean blank sheet on the glass, then close the lid. Load about five sheets into the rear paper feeder and adjust the blue guides to hold them straight.
Step 2:Make a black-and-white copy
Press the black copy button once. Inspect the output for unwanted lines or smears. Because the original is blank, the copied sheet should also be blank.
Step 3:Make a colour copy and check again
Press the colour copy button and inspect that output too. The colour pass may take longer. If marks remain, repeat the blank-copy passes and compare the sheets for improvement.
Inspect each sheet and stop when it comes out clean. Do not assume a fixed number of passes will remove every mark.


