A little preparation

Before you start

  • Access to the rear power cable and paper-feed openings.
  • The paper-size setting from the device that sent the job.
  • Your network setup details if you decide to clear the connection settings.

Start with the printer and paper path

Professor Printer describes all lights blinking as a general printer error, potentially a more serious fault. His sequence is to power off, unplug, inspect for obstructions, check the paper and job settings, then try the reset shown below. The video demonstrates these checks and the button sequence; it does not establish that a particular underlying fault was repaired.

Step 1:Turn the printer off and unplug it

Press the power button until the printer’s lights have gone out. Disconnect the power cord at the rear before opening the printer or reaching into its paper path.

Watch this section at 0:15

Step 2:Check the front opening and under the scanner unit

Open the front cover and raise the upper scanner unit from the front, as shown in the video. Look inside for trapped paper or anything out of place.

Step 3:Check the feeder, lower opening and scanner lid

Inspect the paper-feed opening and look underneath through the lower opening demonstrated in the video. Support the printer if lifting it for a view; tilting an ink-tank printer can spill ink, so protect the surface.

Check the rear paper feeder for trapped sheets. The presenter suggests chopsticks or tweezers to reach accessible paper: use them on the paper, not on printer parts. Finally, lift the scanner lid and check for anything trapped beneath it.

Step 4:Match the print job to the loaded paper

Check the paper size selected on the computer or phone against the paper in the rear feeder. The presenter calls out A4, Letter and photo paper as examples: select the size actually loaded and supported by your printer, rather than treating them as interchangeable.

Watch this section at 1:33

Step 5:Try the power-and-information reset shown in the video

With the printer off, reconnect its power cable. Press and hold the power and information buttons together. The narration gives about 5–10 seconds: release when both Wi-Fi lights begin flashing, then allow roughly another 10 seconds for the demonstrated reset sequence.

Use the light-state cue as well as the approximate timing. The video presents this as an attempt to recover from the error, not a guarantee that a mechanical problem or other fault has gone away.

Watch this section at 1:58

Check the lights and reconnect

Look to see whether the original all-lights warning has stopped. If you used the reset, reconnect the printer to Wi-Fi and your devices before trying a network print again. The accompanying setup guide covers that connection process.

If the original warning remains, the demonstrated sequence has not resolved your fault. The source does not provide a further internal repair procedure or show that repeating the reset repairs it.

A little extra help

Questions & troubleshooting

Will this reset preserve the Wi-Fi connection?

No. The presenter explicitly says Wi-Fi and device-connection settings are reset. Reconnect them afterwards.

What if all the lights still blink after the reset?

The demonstrated checks have not resolved your fault. Further diagnosis of the actual problem is needed; repeatedly resetting the connection does not establish that an internal fault has been repaired.

References